DKS202-M24 plus Baseus Spacemate 11 in1

I'm trying to use DKS202-M24 for my PC plus laptop. Laptop has usbc video support (Lenovo 21g2000rmh to be exact), and I use the Baseus Spacemate 11 in 1 basically as USBC < - > DP converter. The monitors I have are a Gigabyte M34WQ and Dell U2415. Everything works fine if the monitors are connected directly to the Baseus station. If I connect monitors via DKS202, it stops recognizing my Dell U2415 and reports it as Wired Monitor. And it shows only 1920x1080 resolution, while the monitor supports 1920x1200. This one issue I sorted out by adding a custom resolution using the CRU tool. The bigger issue is that if I switch the KVM input to my PC and then switch back to the laptop, the Dell monitor goes black and shows no signal. I need to disconnect the DP cable from Baseus and connect it again, forcing monitor re-recognition on laptop and it starts working again. 

Is there smth to be done so it functions properly via Baseus?

The Dell monitor works fine on PC

M34WQ monitor always gets recognized properly and works fine on both P{C and laptop.